6. Image Stabiliser
DVQX1961 (ENG)
76
Press 34 to select the lens information to
use and then press or .
0
In the default setting, the lens information for
6 lenses with a focal length of between 24 mm
and 135 mm is registered.
The lens information for up to 12 lenses can be
registered.
Registering, modifying, and deleting lens information
1
Press 34 to select the lens information and then press [DISP.].
0
If lens information that has not been registered is selected, press or
to proceed to Step 3.
2
Press 34 to select [Edit] or [Delete] and then press or .
0
The lens information is deleted when you select [Delete].
3
Enter the lens information.
0
The lens information changes if the lens information has already been
registered.
4
(If lens information that has not been registered is selected) Press
[DISP.] to register the lens information.
[Image Circle]
Select the image circle for the lens.
[FULL]: Full-frame lens
[S35mm]: Lens for Super 35 mm/lens for APS-C
[Focal Length] Enter the focal length.
[I.S. Area]
You can set the range of stabilisation for the image stabiliser so
that vignetting does not occur due to the image stabiliser.
[70%]/[80%]/[90%]/[100%]
0 Rotate to select the range of stabilisation, then press
or to confirm.
0 When the four edges are selected by pressing 3421, the
in-body image stabiliser works and you can see if there is any
vignetting. If vignetting has occurred, set again to a smaller
range.
[Lens Name]
Register the lens.
0 For information on how to enter characters, refer to page 167.
DC-S1HGN-DVQX1961_eng.book 76 ページ ２０１９年８月８日 木曜日 午後５時５５分
To Next Page
Loading...
