Panasonic Minas A4 Series - Page 15

13
[Before Using the Products]
Before Using
the Products
Guideline for Parts Replacement
Use the table below for a reference. Parts replacement cycle varies depending on the actual operating
conditions. Defective parts should be replaced or repaired when any error have occurred.






Driver










Motor





Motor with
gear reducer
Smoothing capacitor 
Cooling fan 

Aluminum electrolytic 
capacitor (on PCB) 

Rush current 
preventive relay



Rush current preventive 
resistor
Bearing 

Oil seal 
Encoder 



Battery 
for absolute encoder


Gear reducer
Product Component
Standard replacement
cycles (hour)
Note
These hours or cycles are
reference.
When you experience any
error, replacement is required
even before this standard
replacement cycle.
Approx. 5 years 
2 to 3 years
(10,000 to 30,000 hours)

Approx. 5 years

Approx. 100,000 times
(depending on working
condition)
Approx. 20,000 times
(depending on working
condition)
3 to 5 years
(20
,000 to 30 ,000 hours)
5000 hours
3 to 5 years
(20
,000 to 30 ,000 hours)
Life time varies depending
on working conditions.
Refer to the instruction
manual attached to the
battery for absolute
encoder.
10,000 hours
Prohibited
Disassembling for inspection and repair should be carried
out only by authorized dealers or service company.