1. Connect the IP-PT to the network and
apply power (PoE or AC Adaptor etc)
SETUP
Searching…
2. When the IP-PT powers on, press the
‘SETUP’ soft-key below the LCD display
4.1 Manual Registration Mode – NT
series
When registering an IP-PT without a local DHCP server OR when registering an IP-PT from a remote
location etc, you will need to enter the IP Address of the IP-PT AND the IP Address of the PBX into
the IP-PT manually (Manual Registration Mode).
1. Registering an IP-PT to the PBX (Manual Registration Mode)
To Next Page
Loading...
