1. Connect the UT to the network and
apply power (PoE or AC Adaptor etc)
2. When the UT powers on, press the
‘SETUP’ soft-key below the LCD display
3.2 Manual Registration Mode – UT series
1. Registering an UT-PT to the PBX (Manual Registration Mode)
When registering a UT without a local DHCP server OR when registering the UT from a remote
location etc, you will need to enter the IP Address of the UT AND the IP Address of the PBX into the
UT manually (Manual Registration Mode).
Setup
Now starting…
To Next Page
Loading...
