12.6. Removal of G-P.C.Board
(1) Remove the upper case according to the section 12.2. "Removal
of Upper Case".
(2) Unscrew the 2 screws and remove the blindfold board.
(3) Unscrew the 6 screws and remove the connection terminals
panel with S-P.C.Board and SL-P.C.Board.
(4) Unscrew the 4 screws and remove the signal processing block.
(5) Unscrew the 3 screws and remove the NN-Module.
32
PT-DZ12000U / PT-DZ12000E / PT-D12000U / PT-D12000E / PT-DW100U / PT-DW100E
To Next Page
Loading...
