12.17. Removal of Ballasts 1 and 2 (B/Q-Module)
(1) Remove the upper case according to the section 12.2. "Removal
of Upper Case".
(2) Unscrew the 2 screws and remove the blindfold board.
(3) Unscrew the 6 screws and remove the connection terminals
panel with S-P.C.Board and SL-P.C.Board.
(4) Unscrew the 2 screws and remove the ballast reinforcement
metal fittings.
(5) Loosen each of 3 screws until they idle, remove the lamp units 1
and 2.
(6) Unscrew each of 1 screw and release 2 lamp unit terminals of the
ballast block L.
40
PT-DZ12000U / PT-DZ12000E / PT-D12000U / PT-D12000E / PT-DW100U / PT-DW100E
To Next Page
Loading...
