Panasonic PT-RZ670

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 53
1) Press asqw to adjust the focus.
LENS
FOCUS
ADJUST
2) Press the <MENU> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press as to select the display language.
ENTER
1/7
Please select DISPLAY LANGUAGE.
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (operation setting)
Set the items for the operating method depending on the projector’s application and duration of usage.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu. If you change the settings
while using the projector, the duration until the light source luminance decreases by half may shorten or the luminance may decrease.
By using this initial setting (operation setting), you can complete the settings at once when installing the projector, if the operation method of
the projector is determined in advance. If [ALL USER DATA] is executed from the [PROJECTOR SETUP] menu → [INITIALIZE], press the
<ENTER> button without changing the initial setting (operation setting), and proceed to the next initial setting (installation setting). If you need
to change the setting, ask the person responsible for this projector (such as a person in charge of equipment or operation).
2/7
100%
100%
INITIAL SETTING
SET
CHANGEMENU SELECT
OPERATING MODE
CONSTANT MODE
NORMAL
OFF
LINK
GROUP A
ENTER
CALIBRATION TIME
OFF
CALIBRATION MESSAGE
ON
BRIGHTNESS CONTROL SETUP
LIGHT OUTPUT
MAX LIGHT OUTPUT LEVEL
Set the way to use the projector. For details, please
refer to the operating instructions "When the initial
setting screen is displayed".
Note
f The preceding initial setting screen is displayed when the projector is switched on for the rst time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the settings of [OPERATING MODE] and [MAX LIGHT OUTPUT LEVEL]
set before execution are displayed.
f For the interrelation of luminance and runtime, refer to “Interrelation of luminance and runtime” (x page 55).
f For details on each setting item, refer to the [PROJECTOR SETUP] menu → [OPERATION SETTING].
1) Press as to select [OPERATING MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
f When using the projector at high altitudes of 2 700 m (8 858') or higher above sea level, set [OPERATING MODE] to an item other
than [ECO], [LONG LIFE1], [LONG LIFE2], and [LONG LIFE3].