Panasonic PT-RZ670

Chapter 3 Basic Operations — Switching on/off the projector
54 - ENGLISH
[NORMAL] Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours.
[ECO]
Although the luminance is lower than that of [NORMAL], set this item to increase the life of the light
source. The estimated runtime is approximately 24 000 hours.
[LONG LIFE1]
Although the luminance is lower than that of [ECO], set this item to increase the life of the light
source. The estimated runtime is approximately 43 000 hours.
[LONG LIFE2]
Although the luminance is lower than that of [LONG LIFE1], set this item to increase the life of the
light source. The estimated runtime is approximately 61 000 hours.
[LONG LIFE3]
Although the luminance is lower than that of [LONG LIFE2], set this item to increase the life of the
light source. The estimated runtime is approximately 87 000 hours.
[USER1]
Set [MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] individually.[USER2]
[USER3]
f When [NORMAL], [ECO], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3] is selected, proceed to Step 5).
3) Press as to select [MAX LIGHT OUTPUT LEVEL].
4) Press qw to adjust.
Operation Adjustment Range of adjustment
Press w.
Increases the maximum level of brightness correction.
10.0 % - 100.0 %
Press q.
Decreases the maximum level of brightness correction.
5) Press as to select [LIGHT OUTPUT].
6) Press qw to adjust.
Operation
Adjustment
Range of adjustment
Brightness Runtime (estimate)
Press w.
The screen becomes brighter. The runtime becomes shorter.
10.0 % - 100.0 %
Press q.
The screen becomes darker. The runtime becomes longer.
7) Press as to select [CONSTANT MODE].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not perform the brightness control (correction by the brightness sensor).
[AUTO]
Performs the brightness control (correction by the brightness sensor).
When the brightness of the light source or white balance changes, the brightness of the screen is
automatically corrected.
[PC]
Synchronizes nine or more projectors through a computer using the dedicated software “Multi
Projector Monitoring & Control Software”
*1
.
*1 “Multi Projector Monitoring & Control Software” is included in the supplied CD-ROM.
f When not performing the brightness control ([OFF] is selected), proceed to Step 15).
f When [PC] is selected, proceed to Step 11).
9) Press as to select [LINK].
10) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Performs corrections by the brightness sensor on one projector without synchronizing with other
projectors.
The duration that the constant brightness is kept will become longer by setting the value of [LIGHT
OUTPUT] smaller.
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
Synchronizes corrections on multiple projectors by the brightness sensor.
You can set up to four groups (A to D) within the same subnet by using the network function.
You can also register and synchronize up to eight projectors in one group.
11) Press as to select [CALIBRATION TIME].
12) Press the number (<0> - <9>) buttons on the remote control to enter the time.
f The projector is in the adjustment mode (where the time is blinking).
f Press qw to select “hour” or “minute”.