Panasonic PT-RZ670

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 55
f When the cursor is moved from [CALIBRATION TIME] using as, [CALIBRATION TIME] is xed.
f Brightness and color are measured at the specied time. Iris is xed to open during measurement.
f When not specifying the time, press as to select [CALIBRATION TIME] (the state where the time is not blinking), and press the
<DEFAULT> button.
13) Press as to select [CALIBRATION MESSAGE].
14) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Displays the message during calibration.
[OFF] Does not display the message during calibration.
15) Press the <ENTER> button to proceed to the initial setting.
Interrelation of luminance and runtime
You can use the projector with desired brightness and duration of use by combining the settings of [CONSTANT MODE] in [MAX LIGHT
OUTPUT LEVEL], [LIGHT OUTPUT], and [BRIGHTNESS CONTROL SETUP].
Interrelation of luminance and runtime is as follows. Make the initial setting (operation setting) depending on your desired duration of use and
brightness of the projected image.
Values of the luminance and runtime are rough estimations.
r To set the projector based on the duration of use
Duration of use
(hour)
When [CONSTANT MODE] is set to [OFF] When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Luminance (lm)
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Luminance (lm)
20 000 100.0 100.0 6 500 100.0 54.0 3 500
24 000 100.0 80.0 5 200 100.0 46.0 3 000
27 000 100.0 67.0 4 400 74.0 43.0 2 800
31 000 100.0 46.0 3 000 71.0 37.0 2 400
35 000 ― ― ― 69.0 32.0 2 100
40 000 ― ― ― 66.0 28.0 1 800
r To set the projector based on luminance
Luminance (lm)
When [CONSTANT MODE] is set to [OFF] When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
[MAX LIGHT
OUTPUT LEVEL]
(%)
[LIGHT OUTPUT]
(%)
Runtime (hour)
5 500 100.0 85.0 23 000 100.0 85.0 4 000
5 000 100.0 77.0 25 000 100.0 77.0 7 500
4 500 100.0 69.0 26 500 100.0 69.0 11 000
4 000 100.0 62.0 28 000 100.0 62.0 15 000
3 500 100.0 54.0 29 500 100.0 54.0 20 000
3 000 100.0 46.0 31 000 100.0 46.0 24 000
2 500 100.0 38.0 33 000 72.0 38.0 30 000
2 000 ― ― ― 68.0 31.0 36 500
Note
f Under inuence of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration and
is not the warranty period.