Panasonic PT-RZ670

Chapter 3 Basic Operations — Switching on/off the projector
56 - ENGLISH
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (x page 30)
for details.
Set [HIGH ALTITUDE MODE] to [OVER 2700m] when using the projector at high altitudes between 2 700 m (8 858') and 4 200 m (13 780')
above sea level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press as to select an item.
3/7
ENTER
SET
CHANGEMENU SELECT
It may shorten the life of the light source and projector
if used in incorrect setting.
UNDER 2700m
HIGH ALTITUDE MODE
COOLING CONDITION
AUTO
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
PROJECTION METHOD
FRONT/FLOOR
INITIAL SETTING
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.
Note
f When [OPERATING MODE] is set to [ECO], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3], the item of [HIGH ALTITUDE MODE] cannot
be selected. Use the projector at a location lower than 2 700 m (8 858') above sea level.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the network function during standby.
To keep power consumption low during standby, set this function to [ECO]. After completed the initial setting, you can change the setting from
the [PROJECTOR SETUP] menu → [STANDBY MODE].
1) Press qw to switch the setting.
4/7
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the rst time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu → [INITIALIZE], the setting of [STANDBY MODE] set before execution is displayed.