Pantum CM1100DW Series - Transfer Print Settings

111
Note:
• When your printer performs a certain amount of print jobs, it will automatically
perform color calibration.
• When you replace the laser toner cartridge with a new one, the printer will
automatically perform color calibration.
11.2.3. Transfer Print Settings
If the printed image is mottled or blotchy-looking, you can manually adjust the parameters under
Transfer Print Settings in the following way:
1. Press "Menu" to enter the menu setting interface.
2. Select “Print Settings” by pressing “▲” or “▼”, and then press “OK”.
3. Press “▲”or “▼”, select "Other Settings", and press "OK" to set the parameters under "TP
Settings".
Note:
• You can also set the transfer parameters through the printer setup interface on
computer. Please see Section 7.2.5.