To Next Page

To Previous Page

6.2.3.1. Wireless network

1. Click “Settings” – “Network settings” – “Wireless setup” – “Wireless Network”.

1) If you need to set up wireless network, please click the SSID of access point (wireless router) in

search list, input secret key and click “Apply”.

6.2.3.2. Wireless IP setup

Only when the wireless network of printer is turned on, the Wireless IP Configuration can be

displayed on Web server.

1. Click “Settings” – “Network settings” – “Wireless setup” – “Wireless IP Configuration”.

1) DHCPv4 is ticked by default. If IP address needs to be set up manually, please cancel the

DHCPv4 checkbox ticked and input the “IPv4 Address”, “Subnet Mask” and “Gateway Address” that

you need to set up and then click “Apply”.

6.2.3.3. WPS setup

1. Click “Settings” – “Network settings” – “Wireless setup” – “WPS”.

1) Select the “WPS Startup Method” you need, and then click “Apply” and operate according to

page prompt.

6.2.3.4. Wi-Fi Direct setup

1. Click “Settings” – “Network settings” – “Wireless setup” – “Wi-Fi Direct”.

Note:

• If Auto selected, the mobile terminal will realize automatic connection upon initiating the

connection invitation without the need of confirmation on panel.

• If Manual selected, the mobile terminal cannot realize connection until initiating the

connection invitation prior to confirmation on panel.

6.2.4. Machine setup

You can add mail address contacts, set up e-mail notification, set up sleep time and recover factory

settings via machine setup page.

6.2.4.1. Set up e-mail notification

If you set up e-mail notification, an e-mail will be sent to the mail address specified by you when

abnormality such as paper out occurs. You can receive emails only if you made correct email setup.

Please consult your network administrator for detailed setup steps. You need to log in the

embedded Web server before setting up email notification (please refer to Chapter 6.1 for login

method).

I. Set up SMTP client

1. Click “Settings” – “Network settings” – “Protocol Settings” – “SMTP”.

2. On SMTP page, input SMTP server address, set up the mailbox login name and password and

then click “Apply”.

II.Add recipient address

1. Click “Settings” – “Machine settings” – “Address Book” .

2. Press “Email Address Book” - “New”, enter the contact name and email address, and then press

“Apply”.

III. Set up email notification

1. Click “Settings” – “Machine settings” – “E-mail Notification”.

Pantum CM1100DW Series User Manual

Questions and Answers: