62
6.2.4.3. Configure the FTP address book
If you want to scan a file to the FTP server, you need to configure the FTP address book first.When
scanning, you may send the image scanned to the FTP server.Before configuring the FTP address
book, you may need to ask your network administrator for the
1. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
2. Click "Settings", "Machine Settings" and then "FTP Address Book" to enter the setting interface of
FTP address book.
3. Click "Create" to pop out a window as below and set relevant parameters; after settings
completed, and then click "Apply".
6.2.4.4. Sleep time setup
If you want to change the sleep time of the printer, you can set it via the embedded Web server (the
printer installed via network connection).
1. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
2. Click “Settings” – “Machine settings” – “System”.
3. Select sleep time according to you need and then click “Apply”.
6.2.5. Recover factory settings via Web server
1. Log in the embedded Web server (please refer to Chapter 6.1 for login method).
2. Click “User Management” and then click “Restore to Factory Settings” to recover factory settings.
The printer will restart automatically after factory settings recovery is finished.
• After factory settings of printer are recovered, user name of the administrator will be
recovered to admin and the login password will be recovered to 000000.
• You can also recover factory settings via keys on the control panel of printer, please refer
to Chapter 11.1.4.
To Next Page
Loading...
Need help?
General