6
• Short press Wi-Fi button to turn on direct Wi-Fi connection of the
printer and automatically print out "Mobile Device Wi-Fi Connection
Wizard" page (for models with Wi-Fi function only).
• Long press Wi-Fi button for over 2s to start WPS when Wi-Fi is not
connected or to disconnect Wi-Fi when it has already been connected
(for models with Wi-Fi function only).
• Open save toner function (applicable to non-Wi-Fi model only).
• This is used to start relevant operations after finishing operation
settings.
• In case of a feed failure, please press this key for pick-up and printing
again.
• Press this button to enter into Bill Copy mode.
• Execute cancel operation.
• Idle state interface under copy mode, to reset the "Number of Copies"
to 01.
• Indicate the status of printer.
1.4.2. Function of power indicator
Status displayed by
power indicator
The printer is powered off.
Printer is not in sleep state (printer ready, printing,
processing, etc).
The printer is in sleep state.
To Next Page
Loading...
Need help?
General