52
1) Use WPS method to perform steps below to start wireless network on printer. (Please refer to
Chapter 5.1.2 for detailed WPS configuration)
2) Judge if the printer is successfully connected according to the status of Wi-Fi indicator on printer.
If configuration failed, please click “Previous” to configure again; if configuration succeeded, please
click “Done” to complete configuration.
• If the printer cannot be used normally after wireless network setup is finished, please
install the drive again.
5.1.2. Wi-Fi Protected Setup (WPS) setup
If the access point (wireless router) supports Wi-Fi Protected Setup (WPS), the Wi-Fi key on the
control panel of printer and WPS key on access point (wireless router) can be pressed in order to
connect the printer to wireless network.
To Next Page
Loading...
Need help?
General