12 Reference & Installation Manual
3.0 PROGRAMMING
Programming the DGP2-641 or DGP2-641AC LCD keypads is
simple. Enter the Module Programming Mode, enter the desired
section followed by the required data. When programming the
keypad, use the keypad’s programming sheets (found in the Digiplex/
DigiplexNE Modules’ Programming Guide) to keep track of which
sections were programmed and how. We strongly recommend you
read this entire manual before you begin programming.
The LCD keypad can also be programmed using the WinLoad
Security System Management Software. For more information, refer
to the WinLoad instructions or visit our web site at www.paradox.ca.
3.1 ENTERING MODULE PROGRAMMING MODE
The keypad, like all other modules in the system, is programmed
through the control panel. To do so, you must first enter the Module
Programming Mode:
Step 1: From Normal Mode press and hold the [0] key.
Step 2: Enter the [
INSTALLER CODE] (by default 000000).
Step 3: Enter section [953] (DGP-48) / [4003] (DGP-NE96).
Step 4: Enter the keypad’s 8-digit [
SERIAL NUMBER].
Step 5: Enter the 3-digit [
SECTION] you want to program.
Step 6: Enter the required [
DATA].
The control panel will then redirect all programming to the selected
keypad. Every time the [
CLEAR] key is pressed it will revert to the
preceding step, unless entering in data in which case it will erase the
current data entry. Please note that the serial number is located on
the keypad's PC board or enter section [000] in Step 3 to view the
keypad’s serial number.
To Next Page
Loading...
Need help?
General
