24 Reference & Installation Manual
6.2.1 READER’S LED TO FOLLOW PARTITION’S STATUS
SECTION [003]: OPTION [6]
The reader's LED can be programmed to flash according to
the partition's status. When this feature is enabled, the
reader’s red LED will flash when the partition is arming, in Exit
Delay, in Entry Delay, in Burglar Alarm or in Fire Alarm.
Option [6] OFF= The reader's LED will not flash.
Option [6] ON = LED follows the door’s partition status
(default).
6.2.2 READER’S BEEP TO FOLLOW PARTITION'S STATUS
SECTION [003]: OPTION [7]
This feature will only function when section [003] option [6] is
enabled. The reader can be programmed to beep according to
its keypad's beep when the partition assigned to the door is
arming, in Exit Delay, in Entry Delay, in Burglar Alarm, or in
Fire Alarm.
Option [7] OFF= The beep will not follow the partition's status.
Option [7] ON = Beep follows the partition's status (default).
6.2.3 READER FEEDBACK
SECTION [005]: OPTION [8]
The reader can be programmed to give visual feedback only
(the reader’s LED flashing) or both visual and audible
feedback (the reader will flash and beep).
Option [8] OFF= The reader’s feedback is visual only (default).
Option [8] ON = The reader’s feedback is both visual &
audible.
To Next Page
Loading...
