18 Reference & Installation Manual
4.11 BEEP ON TROUBLE
SECTION [005]: OPTIONS [1] TO [4]
Potential troubles have been sorted into groups. With these options
enabled, the keypad will emit an intermittent beep tone whenever a
trouble condition from the Trouble Groups occurs in the system. The
intermittent beep will remain activated until the user enters the
Trouble Display or if the trouble is resolved. For a list of the troubles,
see the Digiplex or DigiplexNE Reference and Installation Manual.
The intermittent beep will be re-initialized whenever the trouble
condition re-occurs. By default, options [1] to [4] are OFF.
O
ption [1] OFF= Beep disabled: System Troubles and Clock Loss.
Option [1] ON = Beep enabled: System Troubles and Clock Loss.
Option [2] OFF= Beep disabled: Communicator Troubles.
Option [2] ON = Beep enabled: Communicator Troubles.
Option [3] OFF= Beep disabled: Module and Network Troubles.
Option [3] ON = Beep enabled: Module and Network Troubles.
Option [4] OFF= Beep disabled: all Zone Troubles.
Option [4] ON = Beep enabled: all Zone Troubles.
4.12 KEYPAD TAMPER ENABLE
SECTION [006]: OPTION [5]
When tamper is enabled and the keypad's on-board tamper switch is
triggered, the keypad will send a Tamper report to the control panel
via the communication network.
Option [5] OFF= Keypad's tamper is disabled (default).
Option [5] ON = Keypad's tamper is enabled.
To Next Page
Loading...
