Digiplex/DigiplexNE LCD Keypad 39n
Holidays: Days programmed in the control panel that are
not considered normal work days, such as legal,
religious, and feast days.
Pre-Alarm: A beep tone warning that an Access Alarm will
be generated if a protected door is not closed
within a specified period.
Reader: An Access Control device (PosiProx CR-R880-A
or PosiPIN CR-R885-BL) normally located near
a protected door that serves to relay the
information from an Access Control card
presented to it to the control panel.
Request for Exit: When a REX device (Paradoor 460) installed
above an Access Control door within a protected
area detects movement, it sends a signal to the
control panel to permit a user to leave the
protected area. This signal is a “Request for
Exit” event that is logged in the Event Buffer, but
can only be seen through an Access Control
keypad (DGP2-641AC) and cannot be reported
to a Monitoring Station.
Schedule: Schedules determine the hours, days, and
holidays that users are permitted access.
Valid Card: An Access Control card presented to a reader
during its assigned Schedule and within its
assigned Access Level.
To Next Page
Loading...
