Parkside PTBMOD 710 C3 - English; Introduction

22
GB MT
Content
Introduction ...............................22
Intended purpose .......................23
General description ....................23
Extent of the deliver y ......................23
Description of functions ................... 23
Over view ...................................... 23
Technical Data ............................24
Notes on safety..........................24
Introduction
Congratulations on the purchase of your
new device. With it, you have chosen a
high quality product.
During production, this equipment has
been checked for quality and subjected
to a nal inspection. The functionality of
your equipment is therefore guaranteed. It
cannot be ruled out that residual quantities
of water or lubricants will remain on or in
the equipment/hose lines in isolated cases.
This is not a fault or defect and it repre-
sents no cause for concern.
Translation of the original
EC declaration of conformity ....266
Exploded Drawing ...................281
Symbols and icons .........................24
General Safety Directions
forPower Tools ..............................25
Safety information for drills .............27
Safety Instructions for Handling the
Laser ............................................28
Additional Safety Instructions ........... 28
Assembly ...................................28
Operation ..................................29
Selecting the speed ........................29
Adjusting the height of the motor unit ..30
Preselecting the drilling depth ..........30
Changing the bit ............................ 30
Positioning and clamping the work-
piece ............................................30
The operating instructions constitute
part of this product. They contain
important information on safety, use
and disposal.
Before using the product, familiarise
yourself with all of the operating
and safety instructions. Use the prod-
uct only as described and for the
applications specied.
Keep this manual safely and in the
event that the product is passed on,
hand over all documents to the third
party.
Adjusting the laser .........................31
Using the parallel guide .................. 31
Switching the work light / laser
on or off .......................................31
Switching on and off ......................31
Drilling .........................................32
General Information .......................32
Removing Blockages .......................32
Cleaning and maintenance ......... 32
Cleaning .......................................33
Replacing the drill chuck .................33
Storage ......................................33
Transport ................................... 33
Waste disposal and
environmental protection ...........33
Guarantee .................................34
Repair Service ............................35
Service-Center ............................35
Importer ....................................35
Replacement parts/Accessories ..36
Troubleshooting .........................36