Parkside PTBMOD 710 C3 - General Safety Directions for Power Tools

25
GB MT
Precaution symbol with information
on prevention of harm / damage.
Connect the machine to the power
supply.
Pull out the mains plug.
Notice symbol with information on
how to handle the device properly.
Caution! Hot surface. There is a
risk of burns.
General Safety Directions
forPower Tools
WARNING! Read all safety
notices, instructions, illustra-
tions and technical data that
have been provided with this
power tool. Omissions in the
compliance with safety directions
and instructions can cause electrical
shock, re and/or severe injuries.
Retain all safety directions and
instructions for future use.
The term „power tool“ in the warnings
refers to your mains-operated (corded)
power tool or battery-operated (cordless)
power tool).
1) WORK AREA SAFETY
a) Keep work area clean and well
lit. Cluttered or dark areas invite ac-
cidents.
b) Do not operate power tools in
explosive atmospheres, such as

Iiquids, gases or dust. Power tools
Do not wear long hair uncovered.
Use a hair net.
Do not wear gloves.
Caution! Risk of injury from rotating
parts!
Protection class II (double insulation)
Electrical machines do not belong
with domestic waste
108x50mm
108x50mm
Caution! - Laser beam
Do not look into the beam!
Laser class 2
108x50mm
Steel
Wood
min
-1
0
500
1000
1500
2000
2500
1 2 3 4 5 6 7 8 9 10 11 12 13
Ø
Speed table
108x50mm
920
1340
1760
2180
2600
500
min
-1
Adjusting the spindle speed
108x50mm
Adjusting the
drilling depth
Symbols used in the instructions:
Hazard symbols with in-
formation on prevention of
personal injury and property
damage.