24
GB MT
Technical Data
Bench Pillar Drill ........... PTBMOD 710 C3
Rated input voltage
U ...... 230 V~ (alternating current), 50 Hz
Motor power P
0
..................710 W (S1)*
Operating mode P..... 900 W (S6 10%)**
Rated no-load rotation speed (n
0
)
Spindle ...................... 500 - 2600 min
-1
Safety class ...........II
(Double insulation)
Protection category...........................IPX0
Weight (with accessories) .... aprox. 9,1 kg
Drill chuck ........................... 1,5-13 mm
PARKSIDE 1/2 - 20 UNF
Spindle stroke .............................. 80 mm
Max. drill diameter
Wood ......................................40 mm
Steel .......................................13 mm
Laser
Laser class ........................................2
Laser wavelength .....................650 nm
Laser power P
0
........................< 1 mW
Sound pressure level
(L
pA
) ....................... 85,7 dB; K
pA
= 3 dB
Sound power level (L
WA
)
measured .......... 98,7 dB(A); K
WA
= 3 dB
* Operating mode S1: Continuous operation
with constant load
** Operating mode S6 10%: Continuous operati-
on with intermittent load (cycle time 10 min). In
order not to heat the motor more than permit-
ted, the motor may only be operated for 10%
of the cycle time with the stated nominal power
and must then continue running for 90% of the
cycle time without a load.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
The specied noise emission value has
been measured according to a standar-
dised testing method and may be used for
comparison with another power tool.
The specied noise emission value can
also be used for a provisional assessment
of the load.
Warning: The noise emissions
may deviate from the specied
values during actual use of the power tool,
depending on how the power tool is being
used and, in particular, what kind of mate-
rial is being worked on.
Safety measures for protection of the ope-
rator are to be determined that are based
on an estimate of the load under the real
operating conditions.
Notes on safety
Caution! When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and re.
Please read all these instructions before
using this electric tool and please keep the
safety instructions.
Symbols and icons
Symbols on the device:
Warning!
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!
Wear ear protection
Wear eye protection
To Next Page
Loading...
