Penlon A200SP - Page 9

A200SP Absorber 3 User Manual
Warnings and Cautions
User mantenance
24 User mantenance s restrcted to cleanng the outsde
surfaces of the absorber - see secton 7
Other procedures detaled n ths manual must be carred
out by traned techncans
Servce and repar operatons must only be carred out by
an engneer traned by the manufacturer The warranty
for ths product s vod f the product s not mantaned n
accordance wth the servce schedule detaled n secton
71, and the procedures publshed n the Servce Manual
for ths product
AUTIONS
1 Do not sterlse (autoclave) the manometer
2 Do not allow any lqud to run nto the electrcal nterface
unt at the rear of the absorber Do not autoclave
3 Do not allow any lqud to run nto the heater unt (f
ftted) Do not autoclave
4 Autoclavng the absorber canster
Dscard the absorbent and dran the condensate from the
canster, then reft the canster to the absorber assembly,
before autoclavng (see secton 84)
5 Autoclave temperatures maxmum temperatures are
lsted n secton 815
6 If the absorber has to be lfted or carred by hand, always
support the weght of the unt under the base
Do not lft the absorber by grppng any of the
components attached to the top of the absorber - the
manometer, adustable pressure lmtng (APL) valve,
breathng crcut connectors, etc
7 Do not use any ventlator wth the A200SP absorber that
does not comply wth EN ISO 8835 Part 2 or BS EN ISO
80601-2-13