Pentair FLECK 5600 SXT - Controller Replacement

Installer manual Fleck 5600 SXT - Maintenance
Ref. MKT-IM-013 / E - 23.09.2020 79 / 104
9.4.3 Controller replacement
1. Using a Philips screwdriver, unscrew(1) and remove the cover(2) paying attention for the
wire.
2. Press the board clips(3) and release the controller cover(6).
3. Using a flat screwdriver, unscrew(5) and remove the controller(4).
4. Remove carefully the wire connectors(7).
5. Connect the new controller, see Electrical connections [
→
Page46].
6. Reverse above procedure steps to rebuild.