9
Charging the Battery
The battery MUST be charged prior to first use.
Follow these steps to charge a new battery and to
recharge a used battery.
1 Make sure the printer is connected to an AC power
outlet with the AC adapter and power cord. See page 8.
2 Make sure the printer is off.
3 Make sure the battery is installed. See page 6.
4 Press the main switch and hold it down for a few
seconds until the green BATTERY indicator light stays lit.
See Figure 6.
This puts the printer in Charge mode, which completely
discharges the battery and then charges it.
The green BATTERY indicator light stays lit continuously
until discharging is completed; then it blinks until
charging is completed.
NOTE:
During the charging cycle, you will not be able
to print.
When the printer finishes charging the battery, it
automatically turns itself off, and the green BATTERY
indicator light goes off.
The entire process should take about 70 minutes.
Setting Up the Printer
Press and hold down
a few seconds
POWER
DATA
BATTERY
CHARGE
REFRESH
ON
OFF
Green BATTERY light
Main
switch
FIGURE 6. Charging the battery.
To Next Page
Loading...
Need help?
General
