55
Technical Information
Radio & Television Interference
United States FCC Regulations
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
The use of a shielded cable is required to comply with
Class B limits of FCC Rules.
Any changes or modifications not expressly approved by
Pentax Technologies could void the user’s authority to
operate this equipment.
You may purchase a booklet prepared by the FCC entitled
“Interference Handbook,” stock number ISBN 0-16-041736-8,
from the Superintendent of Documents, U.S. Government
Printing Office, Washington, D. C. 20402.
To Next Page
Loading...
Need help?
General
