52 Pentax PocketJet Printer User’s Guide
Pages Are Partially Printed
The green DATA indicator light goes out
while a page remains in the printer.
The software application did not send a full page of data.
Remove the paper from the printer by pressing the main
switch once quickly to “form feed” the incomplete page.
This problem is usually caused by giving the printer the
wrong information about paper size or by using a sheet
longer than the page that the operating system or
application told the printer to expect.
If you are using DOS “PRINT” or “COPY” commands or a DOS
application that does not send PCL printer setup information
prior to the print job, check the settings of the DIP switches
that control the default character set. The printer ejects the
first 11 inches of A4 or legal paper when the default setting for
paper size is “letter.” See page 26.
The printer ejects a partially printed page,
and the green DATA indicator light remains
lit or blinking.
If you are sending many fonts or a large bit-mapped
graphic image to the printer, it may not have sufficient
memory to print the entire page. Insert the page again, and
the printer will print the rest of the image starting where the
previous portion of the image ended.
See “Tips on Printing Large Graphics” on page 31.
The printer stops printing. The POWER
indicator light is blinking and the BATTERY
indicator light is off.
The print head has overheated. Turn the printer off and allow
it to cool before continuing to print. The printer may
overheat if you use it over an extended period at a very
high print density.
To Next Page
Loading...
