Pentax PocketJet - Removing the Battery

11
Removing the Battery
1 Open the printer’s battery cover by pressing the
cover latch. Swing the cover open and remove it.
2 Pull out on the battery removal ribbon as shown in
Figure 7 until the battery starts to tilt out of its
compartment.
NOTE:
If the battery removal ribbon is caught behind
the battery, insert a thin metal object such as a flat-
blade screwdriver between the battery and the case
at the end away from the AC adapter receptacle.
Gently push the battery toward the AC adapter re-
ceptacle and tilt it out of its compartment.
3 Remove the battery from the compartment.
4 Squeeze the connector tab on the battery connector
down.
5 Gently pull the battery connector from the terminal
inside the printer.
Setting Up the Printer
CHARGE
REFRESH
ON
OFF
POWER
DATA
BATTERY
PARALLEL/SERIAL
AC ADAPT.
!
Removal
Ribbon
Battery
Connector
Pull ribbon out
Squeeze
connector
tab down
2
4
Tilt battery out
3
Gently pull
connector out
5
FIGURE 7. Instructions for removing the battery.