210
7
Settings
You can save battery power by setting the display to dim automatically
when no operation is performed for a fixed time. After the power saving
function has been activated, the display returns to the ordinary
brightness by pressing any of the buttons.
1
Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2
Use the four-way controller (23) to select [Power
Saving].
3
Press the four-way controller (5).
A pull-down menu appears.
4
Use the four-way controller (23)
to select the time until the camera
enters power saving mode.
Choose from [2min.], [1min.], [30sec.],
[15sec.], [5sec.] or [Off].
5
Press the 4 button.
The setting is saved.
Using the Power Saving Function
• Power Saving does not function in the following situations:
- while taking pictures in continuous shooting mode
- in the playback mode
- during movie recording/playback
- while the camera is connected to a computer
- when using the AC adapter
- while a menu is being displayed
- while using the VIDEO output
- when switching to the viewfinder using the EVF/LCD button
• When no operation is performed after the camera is turned on, Power
Saving is activated only after 15 seconds elapse even if [5sec.] is set.
Setting
Power Saving
Auto Power Off
USB Connection
Video Out
2/3
MENU
Cancel
OK
OK
2
min.
Off
5
sec.
30
sec.
1
min.
15
sec.
Quick Zoom
Brightness Level
e_kb484.book Page 210 Wednesday, March 18, 2009 5:23 PM
To Next Page
Loading...
