125
3
Taking Pictures
Have a blank sheet of white paper or similar material ready.
1
In the [White Balance] screen, use the four-way
controller (23) to select K (Manual).
2
Point the camera at the blank
sheet of paper or other material so
that it fills the frame displayed in
the center of the screen.
3
Press the shutter release button fully.
The white balance is automatically adjusted.
4
Press the 4 button.
The setting is saved and the screen returns to the [
A
Rec. Mode] menu.
5
Press the 3 button.
The camera returns to capture status.
You can select the sensitivity to suit the brightness of the surroundings.
Manual Setting
Setting the Sensitivity
AUTO The sensitivity is automatically adjusted by the camera. (Sensitivity 50 - 800)
50
The lower the sensitivity, the less noise that affects the image. The
shutter speed will be slower in low light conditions.100
200
400
800
1600
Higher sensitivity settings use faster shutter speeds in low light
conditions to reduce camera shake, but the image may be affected by
noise.
3200
6400
When the [Bright Area Adj.] is set to on, the sensitivity cannot be set to
50.
White Balance
Cance
l O KCancel OK
MENU
Adjust
D
SHUTTER
OK
e_kb484.book Page 125 Wednesday, March 18, 2009 5:23 PM
To Next Page
Loading...
