Pentax X70 - Portrait Photography Modes

84
3
Taking Pictures
The digital zoom is set to O (On) in the default settings. To take pictures
using only the optical zoom and Intelligent Zoom, set the digital zoom to
P (Off).
1 Press the 3 button in A mode.
The [A Rec. Mode] menu appears.
2 Use the four-way controller (23) to select [Digital
Zoom].
3 Use the four-way controller (45)
to select O (On) or P (Off).
O(On) Uses Digital Zoom
P (Off) Uses only optical zoom and
Intelligent Zoom
The setting is saved.
4 Press the 3 button.
The camera returns to capture status.
• It is recommended to use a tripod to prevent camera shake when
taking pictures at a high magnification rate.
• Pictures taken in the digital zoom range appear grainier than pictures
taken in the optical zoom range.
• Intelligent Zoom is not available under the following conditions:
- when the recorded pixels is set to E / / / (24× optical
zoom and Digital Zoom are available)
-in c (Digital SR) mode (only 24× optical zoom is available)
- when the sensitivity is set to 3200 or 6400 (only 24× optical zoom is
available)
• The image enlarged using Intelligent Zoom may appear rough on the
display. This does not affect the quality of recorded image.
• While recording a movie, only Digital Zoom is available.
To Set the Digital Zoom
Saving the Digital Zoom Function setting 1p.147
3:2 16:9 1:1
Rec. Mode
Memory
Green Button
MENU
Exit
3/4
Blink Detection
Digital Zoom
Instant Review
Interval Shoot
e_kb484.book Page 84 Wednesday, March 18, 2009 5:23 PM