peplink Balance 30 - 5.4.2 LCD Display Menu

PePLink Balance Series v4.0 User Manual
Page 15
5.4.2 LCD Display Menu
> System Status
> System
> Firmware ver (shows firmware version)
> Serial number (shows serial number)
> System time (shows current time)
> System up time (shows up time since server reboot)
> CPU load (shows current CPU loading, 0-100%)
> LAN
> Status (shows LAN port physical status)
> IP address (shows LAN IP address)
> Subnet mask (shows LAN subnet mask)
> Link status (shows Connected/Disconnected, IP address list)
> WAN1
> WAN2
> …
> WAN7
> Link usage
> Throughput in (shows transfer rate in Kbps)
> WAN1
> WAN2
> …
> WAN7
> Throughput out (shows transfer rate in Kbps)
> WAN1
> WAN2
> …
> WAN7
> Data Transfer’d (shows volume transferred since last reboot in MB)
> WAN1
> WAN2
> …
> WAN7
> Maintenance
> Power off > Power off? (Yes/No) (powers off unit)
> Reboot > Reboot? (Yes/No) (reboots unit)
> Factory default > Factory default? (Yes/No) (restores factory defaults)
> LAN config
> Port speed (shows port speed: Auto, 10baseT-FD,
> LAN 10baseT-HD, 100baseTx-FD,
> WAN1 100baseTx-HD, 1000baseTx-FD)
> WAN2
> …
> WAN7