PePLink Balance Series v4.0 User Manual
6.2.4 Mac DHCP Client Configuration
1. Open TCP/IP Control Panel.
2. From the Connect via pop-up menu, select Ethernet.
3. Select Using DHCP Server from the Configure pop-up menu.
(The DHCP Client ID field can be left blank.)
4. Save the settings and close the TCP/IP Control Panel.
6.2.5 UNIX DHCP Client Configuration
Depending on the flavor of UNIX, the procedure may vary. The following steps are for Red
Hat Enterprise Linux 3:
1. Login to the system as root.
2. At the command prompt, type netconfig.
3. When prompted with the following:
Would you like to set up networking?
Respond with Yes.
4. When prompted with the following:
Please enter the IP configuration for this machine…
Select the option:
Use dynamic IP configuration (BOOTP/DHCP)
5. Select OK.
To Next Page
Loading...
