PePLink Balance Series v4.0 User Manual
Inbound / Outbound Firewall Settings
This setting specifies whether or not to log matched firewall events.
The logged messages are shown on the page Status > Logs:
A sample message is as follows:
Aug 13 23:47:44 Denied CONN=WAN1 SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
CONN: The connection to which the log entry refers.
Possible values are LAN and WANx, where x is the WAN number.
SRC: Source IP address
DST: Destination IP address
LEN: Packet length
PROTO: Protocol
SPT: Source port
DPT: Destination port
This specifies the source IP address(es) and port number(s) to be
matched for a firewall rule.
A single address, or a network, can be specified as the Source IP &
Port setting, as indicated with the following screenshots:
In addition, a single port, or a range of ports, can be specified for the
Source IP & Port setting, as the following indicates:
To Next Page
Loading...
