PePLink Balance Series v4.0 User Manual
Inbound / Outbound Firewall Settings
This specifies the destination IP address(es) and port number(s) to be
matched for a firewall rule.
A single address, or a network, can be specified as the Source IP &
Port setting, as indicated with the following screenshots:
In addition, a single port, or a range of ports, can be specified for the
Source IP & Port setting, as the following indicates:
This setting specifies the action to be taken by PePLink Balance upon
encountering traffic that matches the both of the following:
Source IP & Port
Destination IP & Port
With the value of Allow for the Action setting, the matching traffic
passes through PePLink Balance (to be routed to the destination).
If the value of the Action setting is set to Deny, the matching traffic
does not pass through PePLink Balance (and is discarded).
Upon clicking Save after entering required information, the following screen appears.
To create an additional firewall rule, click Add Rule and the above steps.
The “Default” rule specifies the default behavior when none of the rules above match. The
default rule is Allow.
To Next Page
Loading...
