The following steps can be used to test the DNS configuration:
From a host on the Internet, use an IP address of PePLink Balance and nslookup to lookup
the corresponding hostname.
Check the information that is returned for the expected results.
An example with nslookup in Windows follows:
C:\Documents and Settings\User Name>nslookup
Default Server: ns1.myisp.com
Address: 147.22.11.2
> server 202.153.122.108 (This is PePLink Balance’s WAN IP address.)
Default Server: balance.mycompany.com
Address: 202.153.122.108
> www.mycompany.com (This is the hostname to look up.)
Default Server: balance.mycompany.com
Address: 202.153.122.108
Name: www.mycompany.com
Address: 202.153.122.109, 67.38.212.19
The values of the IP addresses are fictitious and for illustration only; the actual IP
addresses in implementation will likely be different.
To Next Page
Loading...
