SWITCHES
3
• To signal a left turn, pull the lever
back (counterclockwise).
• Each time the turn indicator is
activated the audible warning
emits a short beep.
NOTE
If the vehicle turn signals and turn sig-
nal indicators in the dash gauge clus-
ter ever begin ashing at an acceler-
ated rate (115 cycles per minute) when
the turn signal lever is in the OFF (cen
-
ter) position, or when a Right/Left turn
has been selected, the problem may
be related to a failed turn signal switch
or turn signal module. In either case,
the problem is not a failed bulb. Con
-
tact your nearest authorized dealer to
have the problem corrected as soon as
possible.
WARNING!
After you complete a turn, shut the
system off by returning the lever to
the “OFF” (center) position. Failure
to shut off a turn signal could confuse
other drivers and result in an injury ac-
cident. An indicator light in the instru-
ment panel will ash until the turn sig-
nal is turned off.
High Beam
NOTE
The headlights
must be ON for the
high beam switch to operate.
• To switch your headlights to lower
or higher beam, gently pull the turn
signal lever, toward the steering
wheel, until you hear the switch
click and the beam changes.
The blue indicator light in the
instrument panel will be ON when
the high beam is being used.
• To return to previous beam: pull
the lever towards the steering
wheel again.
• The high beams can be
momentarily ashed with or
without the headlights being on.
To ash the high beams, gently
push the headlight lever away from
the steering wheel to momentarily
turn on the lights.
NOTE
Continued pressing
of the high beam
ash will not keep the high beams on.
3-70 Y53-6047–2C (04/13)
To Next Page
Loading...
