Mounting and commissioning the machine
8 - 3
8.01.03 Mounting the spool holder
● Mount the spool holder as shown in
Fig. 8-03.
● Insert the spool holder into the hole in the
table top and fasten it with the nuts
enclosed.
Fig. 8 - 03
● For machines delivered without a table, the plate 1 from the accessories should be
mounted, so that it is on a level with the bottom edge of the table top and with the left
edge of the table top cutout.
● Set the machine into the table top.
● After loosening screws 3, set switch 2 so that it is activated when the sewing head is in
an upright position.
● In this position tighten screws 3.
93-004
8.01.04 Mounting the start inhibitor
Fig. 8 - 04
1
3
2
To Next Page
Loading...
