Input
11 - 1
11 Input
This chapter describes the input mode functions and how to enter seam programs.
11.01 Input mode
When the machine is in its initial state, it is possible to enter the parameters and the
corresponding values directly in the control unit. The functions information, adjustment of the
transmitted light sensors and service can be called up.
● Switch on the machine.
● Call up the input mode.
Explanation of the functions
Sewing mode
Quit the input mode and call up the sewing mode.
Parameter selection
Select the hundred and unit figures of the desired parameters, see Chapter 13.11.01 Example
of a parameter input.
Altering the parameter value
Change the value of the selected parameter, see Chapter 13.11.01 Example of a parameter
input.
Software information
Calls up information about the current machine software.
Adjusting the transmitted light sensors
Opens the menu for adjusting the transmitted light sensors, see Chapter 13.08 Adjusting the
transmitted light sensors.
Service
Opens the service menu, see Chapter 13.13 Service menu.
A 100
100
To Next Page
Loading...
