Pfaff 2481-980/30 PLUSLINE - Needle in Needle Hole Centre

Adjustment
13 - 11
13.05.09 Needle in needle hole centre
Requirement
The needle should enter the needle hole exactly in the centre.
● Switch on the machine.
● On the control panel set the stitch length at ”0” and turn the balance wheel until the stitch
length control motor reacts.
● By turning the balance wheel position the needle in the needle hole.
● Adjust needle bar frame 1 (screws 2 and 3) according to the requirement.
● Switch off the machine.
Fig. 13 - 10
93-007
2
1
57-035
3
0.0