Mounting and commissioning the machine
8 - 4
8.04 Checking the function of the start inhibitor
● Switch the machine on at the main switch and tilt it over.
The error message "ERRO 9" must appear on the control panel.
● If the message does not appear, check the setting of the start inhibitor as described in
Chapter 8.01.04 Mounting the start inhibitor.
● Set the sewing head upright and acknowledge the error message.
The machine is ready for operation again.
89-007
8.02 Commissioning
● Before commissioning the machine
remove plug 1 from the oil tank 2.
Danger of damage to the
machine!
Plug 1 serves as a safety
device for transportation and
should not be used during
sewing operations.
● Examine the machine, in particular the
electric cables for any damage.
● Clean the machine thoroughly, see also
Chapter 12 Care and Maintenance.
● Have qualified personnel check whether
the machine can be operated with the
available voltage and whether it is
connected properly. If there are any
irregularities do not operate the machine
under any circumstances.
Fig. 8 - 04
1
2
8.03 Switching the machine on/off
● Switch the machine on or off (see Chapter 7.01 On/off switch).
To Next Page
Loading...
