Pfaff 2481-980/30 PLUSLINE - Height of the Bottom Feed Dog; Position in the Needle Plate Cutout

Adjustment
13 - 10
6
7
3
5
4
13.05.08 Height of the bottom feed dog / Position in the needle plate cutout
Requirement
At the top of its stroke, when the stitch length is set at ”0”, the bottom feed dog 1
1. Should be positioned in the centre of the needle plate cutout as seen from the side and
in feeding direction and
2. Rest on the feed dog adjustment gauge 2 over its whole length.
Fig. 13 - 09
● Switch on the machine and set the stitch length at "0".
● Turn the balance wheel until the stitch length control motor reacts.
● Bring the bottom feed dog 1 to the top of its stroke.
● Raise the presser foot, position the feed dog adjustment gauge 2 over the needle plate
cutout with its front edge flush with the edge of the needle plate, as shown in Fig. 13-09,
and lower the presser foot.
● Adjust bracket 3 (screw 4) according to requirement 1.
● Adjust bracket 3 or eccentric 7 (screws 5 and 6) according to requirement 2.
● Switch off the machine.
57-34
2
1
0.0