Input
11 - 2
11.02 Entering the seam program
Seam programs are created by establishing seam sections which are allocated certain
functions and values. It is possible to store up to 65 seam programs each with 15 seam
sections. The maximum number of seam sections in each seam program and the maximum
number of seam programs can be limited by setting appropriate parameters, see Chapter
13.11 Parameter settings.
● Switch on the machine.
● Select a program number, see Chapter 9.11 Selecting the seam program.
● Call up the seam program input function.
Explanation of the functions
Seam program selection
Opens the menu for entering the seam program number or for selecting the manual sewing
mode, see Chapter 9.11 Selecting the seam program.
Edge guide
Opens the menu for entering the seam depth, see Chapter 9.07 Entering the edge guide
position.
Stitch length
Opens the menu for entering the stitch length, see Chapter 9.06 Entering the stitch length.
Selecting the seam type
Shows the current seam program with the corresponding seam sections and opens the menu
for selecting the seam type, see Chapter 11.02.01 Selecting the seam type.
Start backtacks
Switches the start backtack function on or off.
End backtacks
Switches the end backtack function on or off.
3
2.0
0.0
0
3
To Next Page
Loading...
