Input
11 - 3
Needle position raised
When this function is activated, the needle is positioned at t.d.c. after sewing stops.
Presser foot raised
When this function is activated, the presser foot is raised after sewing stops.
Presser foot raised after thread trimming
When this function is activated, the presser foot is raised after thread trimming.
Thread trimming
When the function is activated, thread trimming with the pedal function is possible.
Speed
Opens the speed input menu.
When this function is activated, it is possible to sew the seam section with the set speed,
irrespective of the pedal setting.
Seam end with pedal
When this function is activated, the seam end is initialised manually with the pedal.
Reverse sewing direction
When this function is activated, the corresponding seam section is sewn in reverse.
Sewing stop
When this function is activated, sewing stops automatically at the send of the seam section.
Seam section end with sensor
Opens the menu for entering the seam depth and the correction value for corner stitches, see
Chapter 11.02.02 Entering the seam depth.
When this function is switched on, the sensor recognises the seam end automatically.
Seam section end with stitch counting
Opens the menu for entering the number of stitches for the current seam section.
When this function is activated, the seam section end is initialised by the stitch counting
function.
Selecting seam sections
This function is used to select the seam sections of the current seam program.
Current seam section
Display and selection of the current seam section using the number keys.
Sewing mode
Quit the seam program input mode and call up the sewing mode.
To Next Page
Loading...
