Preparation
9 - 9
9.10 Setting the number of remaining stitches for the bobbin thread control
When the bobbin thread monitor signals that the bobbin thread has been used up, there is still
an amount of remaining thread on the bobbin.
● Switch on the machine.
● Call up the input mode.
● Call up parameter "660".
● Switch on the bobbin thread monitoring function (Value "1").
Explanation of the values for parameter "660" (bobbin thread monitoring):
0 = off
1 = remaining thread counter on
2 = bobbin thread reverse counter on
A 100
100
0
660
A 660
1
To Next Page
Loading...
