Adjustment
13 - 44
13.13 Service menu
In the service menu information is displayed about the machine’s inputs and outputs, the
values of both pedals and the balance wheel position.
In addition the following functions can also be carried out.
● Switch on the machine.
● Call up the input mode.
● Call up the service menu.
Description of the functions
Input mode
Quit the service menu and call up the input mode.
Sewing mode
Quit the service menu and call up the sewing mode.
Set/reset outputs
Using the arrow functions select the desired output and set "function 1" or reset "function 2".
Parameter reset
All parameters are reset to the default values.
Program reset
All programs are reset to the default values.
Sensor menu
After this function has been called up, the transmitted light sensors and the bobbin thread
monitor sensors can be set.
Motors
After this function has been called up, the stepping motors for the feed band , the feed wheel
and the sewing motor can be moved.
Control panel
See Chapter 9.12 Adjusting the control panel.
To Next Page
Loading...
