Adjustment
13 - 45
Plug assignment
CAN
Pin-No. Comment Function Plug marking Signal marking
X11A.2 CAN CAN- CAN_HIGH CAN_TxD
X11A.3 CAN Gnd
X11A.7 CAN CAN+ CAN_LOW CAN_RxD
Set value transmitters
Pin-No. Comment Function Plug marking Signal marking
X11B.4 pedal +5V
X11B.5 pedal +5V
X11B.6 pedal Gnd
X11B.7 pedal 2 set value SW2 (analog)
X11B.8 pedal 1 set value SW1 (analog)
X11B.9 pedal Gnd
Sensors
Pin-No. Comment Function Plug marking Signal marking
X15.1 Sensors current source UFW P7.3
X15.2 Sensors DLS outside (LS2) P5.3 (analog)
X15.3 Sensors DLS inside (LS1) P5.6 (analog)
X15.4 Sensors ZZ-Sensor 2438 E9 E9/Port_E9
X15.5 Sensors current source DLS A10/PortA10 O10
X15.6 Sensors +5V +5V
X15.7 Sensors UFW-Out UFW_MESS
X15.8 Sensors +24V +24V
X15.9 Sensors 0V 0V
RS232
Pin-No. Comment Function Plug marking Signal marking
X1A.1 BDF-S2/T1 +24V +24V
X1A.2 BDF-S2/T1 RxD RxD
X1A.3 BDF-S2/T1 TxD TxD
X1A.4 BDF-S2/T1 +5V +5V
X1A.5 BDF-S2/T1 Gnd Gnd
X1A.6 BDF-S2/T1 -
X1A.7 BDF-S2/T1 RTS RTS
X1A.8 BDF-S2/T1 CTS CTS
X1A.9 BDF-S2/T1 Gnd Gnd
To Next Page
Loading...
