Adjustment
13 - 6
13.05.04 Zero position of the needle feed
Requirement
When the stitch length is set at ”0”, there should be no feeding motion of the needle bar
when the balance wheel is turned.
● Switch on the machine.
● On the control panel set the stitch length at "0" and turn the balance wheel until the stitch
length control motor reacts.
● Make sure that parameter 834 is set at "0", see Chapter 13.11 Parameter settings.
● Adjust crank 1 (screw 2) according to the requirement.
● Switch off the machine.
2
1
Fig. 13 - 05
0.0
To Next Page
Loading...
