Adjustment
13 - 31
13.08 Adjustment of the transmitted light sensors
Requirement
The difference between one and several material plies should be recognised.
● Switch on the machine.
● Call up the input mode.
● Start the adjustment without material.
● End the adjustment without material.
● Start the adjustment with material (e.g. cuff).
● Move the cuff to and fro under the sensors for a short time.
● End the adjustment for with material.
● If necessary, adjust the transmitting power.
● End the adjustment of the transmitted light sensors.
● Call up the menu for adjusting the transmitted light sensors.
A 100
100
0 - 100 % 0 - 100 %20 %
96 - 96 % 33 - 27 %52 %
To Next Page
Loading...
