Adjustment
13 - 38
Group
Parameter
Description
User level
Setting range
Set value
6
606 Speed level 1 (min.) [min-1] B 30 - 550 180
607 Speed level 12 (max.) [min-1] B 300 - 5000 4500
609 Cutting speed [min-1] B 60 - 500 180
618 Reversing angle C ON - OFF OFF
624 St
art inhibitor: C
ON - OFF ON
642 Presser foot – time from switch-on to tension
reduction (tacting)
C 10 - 50 50
651 Automatic lowering of presser foot C ON - OFF ON
660 Bobbin thread monitoring
0 = off
1 = on
2 = bobbin thread reverse counter on
A 0 - 2 1
668 Thread wiper = 1,
Thread clamp = 2,
off = 0
B 0 - 2 2
7
700 Logical zero mark [increments] B 0 - 127 0
702 Needle position (needle lowered) B 0 - 30 15
703 Needle position (take-up lever raised) B 100 - 127 113
705 Needle position (end of cutting signal) B 80 - 127 98
706 Needle position (start of cutting signal) B 40 - 80 68
707 Needle position (start thread tension release) B 40 - 80 70
710 Needle position (needle raised without cutting) B 80 - 127 106
715 Operating time thread wiper [ms] B 0 - 2550 120
718 Moment of standstill brake (rest brake) B 0 - 100 0
719 Presser foot-holding current B 0 - 50 40
720 Cutting–holding current B 0 - 50 40
721 Feed converter-holding current C 0 - 50 40
722 Acceleration ramp:
1 = fl at,
50 = steep
C 1 - 50 50
723 Brake ramp:
1 = fl at,
50 = steep
C 4 - 50 50
To Next Page
Loading...
